AtlasIED Mounting Rings & Squares products are mounting rings and squares used to prepare new-construction openings for compatible speaker assemblies. These are system hardware components, so correct fit depends on the exact speaker size, mounting pattern and building construction.
Verify cutout dimensions, speaker diameter, enclosure depth, ceiling or wall type, finish, mounting method and any fire/plenum listing requirement. Square and round variants that look similar may use different patterns or hardware.
For replacements, identify the existing AtlasIED baffle/backbox part number or the speaker model it supports before ordering. This avoids mechanically compatible-looking parts that do not align with the installed system.
Verify cutout dimensions, speaker diameter, enclosure depth, ceiling or wall type, finish, mounting method and any fire/plenum listing requirement. Square and round variants that look similar may use different patterns or hardware. Representative Wallco listings include WAL07-75-8, WAL07-76-8E2, WAL07-P77-8.
For replacements, identify the existing AtlasIED baffle/backbox part number or the speaker model it supports before ordering. This avoids mechanically compatible-looking parts that do not align with the installed system.
Confirm the application, electrical or network architecture, mounting/environmental requirements and the specific AtlasIED model compatibility described above.
Yes. Provide the existing AtlasIED part number when replacing equipment, or send the system voltage/impedance, application, mounting location and project requirements for new designs.
