92-152-10 | Single IR Flashing Emitter, 6 Ft. Cord, 10 Pack, works with all (+) Tip, (-) sleeve standard Home Automation Systems and all Calrad IR products listed below.
Facts about Mounting the IR emitter to equipment, Please Note! Peel the double stick adhesive tape off of the rear of the emitter to adhere to Audio-Video equipment once the IR receiver window on your equipment is properly located. If the location is confirmed to be working properly, always add a small bead of clear silicone around the outside of the emitter to insure it does not fall off over time due to temperature changes. Blinks-Flashes when IR signals are transmitted.
92-160, IR 6 Port IR Repeater-Distribution System with Gain Control: 92-160 92-180A, IR 6 Port IR Repeater-Distribution System: 92-180A
Specifications Individual Emitter:
Termination Plug: 3.5mm Male (Nickel Plated)
Cable Length: 6 ft.
Cable Gauge: 28Awg x 2
Frequency: Good for all 38Khz-56Khz visable-infrared signal transmissions
