AtlasIED amplifiers cover single-, dual- and multi-channel power amplification, network/DSP platforms, mixer amplifiers, preamplifiers and PoE-connected audio interfaces. The range supports both constant-voltage 25V/70.7V/100V distributed audio and low-impedance 4/8-ohm loads depending on model.
Start with the loudspeaker load and system topology: required wattage, number of zones/channels, line voltage or impedance, input count, mixing/priority needs, DSP/network control and Dante requirements. Amplifier power should include appropriate headroom over the connected speaker taps or low-impedance load.
AtlasIED families such as AA, DPA and AZA address different system roles, so select the architecture before comparing only total watts.
Start with the loudspeaker load and system topology: required wattage, number of zones/channels, line voltage or impedance, input count, mixing/priority needs, DSP/network control and Dante requirements. Amplifier power should include appropriate headroom over the connected speaker taps or low-impedance load. Representative Wallco listings include WAL07-AA-PPRC, WAL07-AA-YSUM, WAL07-AA100PHD.
AtlasIED families such as AA, DPA and AZA address different system roles, so select the architecture before comparing only total watts.
Confirm connected speaker load, channel count, output topology, required headroom, input/routing needs and any DSP, network or Dante requirements.
Yes. Provide the existing AtlasIED part number when replacing equipment, or send the system voltage/impedance, application, mounting location and project requirements for new designs.
